User's Manual

User Guide | FreeSpeak II™
Page 7
8.6.1 Setting the low battery alarm ..................................................... 101
8.6.2 Setting the low battery alarm threshold ....................................... 102
8.6.3 Setting the out of range alarm ................................................... 102
8.6.4 Setting the call alert .................................................................. 102
8.7 Selecting the beltpack role default set ...................................... 103
8.8 Selecting the beltpack administration ....................................... 103
8.8.1 Enabling OTA registration mode.................................................. 104
8.8.2 Setting full menu access ............................................................ 104
8.8.3 Setting system sync mode ......................................................... 105
8.9 Setting the listen again option ................................................. 105
8.10 Accessing beltpack information ............................................... 106
8.11 Setting display mode ............................................................. 106
8.12 Setting system connect .......................................................... 106
8.13 Enabling over the air (OTA) registration mode from a beltpack .... 107
8.14 Performing a site survey ......................................................... 107
9 Operating the transceiver/antenna ................................... 109
9.1 Transceiver/antenna .............................................................. 109
9.1.1 IP rating (International Protection Marking) ................................. 109
9.1.2 FS II transceiver/antenna connector panel ................................... 110
9.1.3 Cabling the antennas ................................................................ 111
9.1.4 Beltpack support capacities for transceiver/antennas .................... 111
9.1.5 Coverage areas under various conditions ..................................... 112
9.1.6 Transceiver/antenna setup rules and tips ..................................... 112
9.1.7 Upgrading the antenna/transceiver firmware ................................ 113
9.2 Transceiver/antenna splitter (PD2203) ..................................... 113
9.2.1 PD2203 Front connector panel .................................................... 114
9.2.2 PD2203 rear panel .................................................................... 115
9.2.3 Connecting an antenna splitter to the FS II Base station and to
transceiver/antennas ................................................................ 116
10 FS II Configuration Editor
................................................. 117
10.1 Loading configurations ........................................................... 118
10.1.1 Loading a local configuration file ................................................. 118