User's Manual
4
DIP SWITCH SETTINGS
Before installing the AVDB, the following six functions can be set by switching/moving the switches as indicated below. Refer to
Figure 3, below.
* = factory setting
Figure 3. SW1 DIP switch on AVDB circuit board
(Default pin positions displayed)
Switch #1 Vehicle Presence Auto Reset
OFF No Timeout
ON 20 minute timeout for vehicle presence *
Switch #2 Detection Sensitivity
OFF Normal Sensitivity *
ON Low Sensitivity
Switch #3 Switch #4 Release Sensitivity
OFF OFF Low
OFF ON Medium *
ON OFF High
ON ON Extra High
Switch #5 Diagnostic Mode
OFF Normal AVDB Operation *
ON
Detection is Suspended - DSP rmware
scrolls, and car presence is cycled every 10
seconds (On 10 seconds, Off 10 seconds)
Switch #6 Switch #7 Delay
OFF OFF 6 seconds
OFF ON 4 seconds
ON OFF 2 seconds
ON ON 0 seconds *
Switch #8
OFF Daily Log
ON Weekly Log *
Clears vehicle detection after 20 minutes.
Lower detection sensitivity corresponds
to slower detection at the risk of small
uctuations causing missed detections.
Release Sensitivity correlates to how
quickly the AVDB will signal vehicle
departure (higher sensitivity means
departures trigger more easily).
Veries connection between AVDB and
Base.
Controls the delay between detection and
the actual signaling of detection.
ON is the default setting. Do not change.
DRAFT