User Manual

6
C. Channels 0 - 7
CAUTION: The HS400 channel setting should not be changed unless it has been
necessary to change the drive-thru audio system base station frequency. Call
HME Customer Support at 1-800-848-4468 for assistance.
•• Note the SW1 DIP switch settings in the System 400 Base Station
•• Match the settings in the base station with one of the horizontal lines on the table in
Figure 6 to determine on which HS400 Channel Setting your headset must be set
NOTE: If the SW1 settings in your base station do not match any of horizontal lines
on this table, call HME Customer Support at 1-800-848-4468 for assistance.
•• To set/change HS400 channels, touch and release A2 button repeatedly until you
hear “Channel (0 through 7).” Stop after you hear the correct HS400 Channel
Setting your headset.
•• To save this channel setting, press the B button. You will hear “Channel
(0 – 7) saved,” and you will be automatically returned to the configuration-settings
mode. NOTE: If you do not press the B button, after 10 seconds the HS400 will be
automatically returned to the configuration-settings mode.
System 400 Base Station
(Base Station #1 in Dual Lane Stores)
SW1 DIP Switch Settings
HS400
Channel
Setting
1 2 3 4 5 6 7 8
0
OFF OFF OFF OFF OFF OFF OFF OFF
1
ON OFF OFF OFF ON OFF OFF OFF
2
OFF ON OFF OFF OFF ON OFF OFF
3
ON ON OFF OFF ON ON OFF OFF
4
OFF OFF ON OFF OFF OFF ON OFF
5
ON OFF ON OFF OFF OFF OFF OFF
6
OFF ON ON OFF ON OFF OFF OFF
7
ON ON ON OFF OFF ON OFF OFF
Figure 6. SW1 DIP switch in
System 400 Base Station