User Manual
6
C. Channels 0 - 7
•• Note the SW1 DIP switch settings in your System 400 Base Station
(Base Station #1 in Dual Lane stores).
•• Match the settings on that SW1 DIP switch with one of the horizontal lines on Table
1 below, to determine on which HS400 Channel Setting your headset must be set.
Refer to the first column in Table 1 for the corresponding headset channel number.
If the SW1 settings in your base station do not match any of horizontal lines
on Table 1, call HME Customer Support at 1-800-848-4468 for assistance.
•• To set/change headset channels, touch and release the A2 button on your headset
repeatedly until you hear “Channel (0 through 7).” Stop after you hear the correct
HS400 Channel Setting number for your headset.
•• To save this channel setting, press the B button. You will hear “Channel (0 – 7)
saved,” and you will be automatically returned to the configuration-settings mode.
NOTE: If you do not press the B button, after 10 seconds the HS400 will return
automatically to the configuration-settings mode with its previous settings.
SW1 DIP Switch Settings for
System 400 Base Station
in Single Lane Stores
- Or -
Base Station #1, Lane One
in Dual Lane Stores
SW1 DIP Switch Settings for
Base Station #2, Lane Two
in Dual Lane Stores (only)
HS400
Channel
Setting
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
0
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
→→
OFF
ON OFF
OFF
OFF
ON OFF
OFF
1
ON OFF
OFF
OFF
ON OFF
OFF
OFF
→→
ON ON OFF
OFF
ON ON OFF
OFF
2
OFF
ON OFF
OFF
OFF
ON OFF
OFF
→→
OFF
OFF
ON OFF
OFF
OFF
ON OFF
3
ON ON OFF
OFF
ON ON OFF
OFF
→→
ON OFF
ON OFF
OFF
OFF
OFF
OFF
4
OFF
OFF
ON OFF
OFF
OFF
ON OFF
→→
OFF
ON ON OFF
ON OFF
OFF
OFF
5
ON OFF
ON OFF
OFF
OFF
OFF
OFF
→→
ON ON ON OFF
OFF
ON OFF
OFF
6
OFF
ON ON OFF
ON OFF
OFF
OFF
→→
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
7
ON ON ON OFF
OFF
ON OFF
OFF
→→
ON OFF
OFF
OFF
ON OFF
OFF
OFF
Table 1. Table 2.
NOTE: In Dual Lane stores, be certain the SW1 DIP switch settings for Base Station #2,
shown in Table 2 above, correspond to the Base Station #1 SW1 DIP switch settings on
the same line of Table 1.
Example: If Base Station #1 SW1 DIP switch is set as shown on Table 1, line 3, Base
Station #2 SW1 DIP switch must be set as shown on Table 2, line 3.
Figure 6. SW1 DIP switch in
System 400 Base Station