User's Manual

Base Station External Features

Front — (See A on Figure 2.)

• Four power supply lights are on when the base station has AC power.

• “A” TALK light is on during channel-A transmission.

• “B” TALK light is on during channel-B transmission.

• VEHICLE PRESENT light is on when a vehicle is present in the drive-thru lane or

when the system is in vehicle-detect override.

• RECORD light is ON RED when the base station is ready to record red message for

the message repeater, and blinking red while red message is being recorded. It is on

GREEN when the base station is ready to record green message for the message

repeater, and blinking GREEN while green message is being recorded.

Bottom — (See B on Figure 2.)

• PUSH FOR RECORD MODE button must be pushed IN and released once to

prepare the base station to record red message for the message repeater, or pushed

IN and released twice to record green message.

Behind Front Door — (See C on Figure 2.)

• MESSAGE REPEATER switches must be switched ON to use the message repeater,

OFF when the message repeater is not being used. Instructions are given on the

inside of the front door.

• SPEED TEAM switch must be switched ON for speed-team operation, OFF for normal

drive-thru operation

• VEHICLE DETECTOR switch must be switched to OVERRIDE to disable vehicle

detector; to reset vehicle detector, switch to OVERRIDE for 5 seconds, then switch

back to NORMAL and leave for normal vehicle detection operation.

• DIP switches at the top are used to control message audio routing to the speakers

and Communicators. DIP switch settings are shown on the inside of the front door.

• Nine level controls are used to set VAA level, Vehicle tone level, audio source levels

at the grill speaker, outbound audio source levels at the outside speaker and the

inbound level from the speaker post microphone.