User's Manual

6
Figure 10.
COM400CC battery charging in the AC910 Battery Charger
Charging COM400CC batteries in the AC910 Battery Charger:
Place up to four COM400CC batteries in the charger for charging at a time. The red Charging
light, adjacent to a battery being charged will blink for a few seconds when the battery is placed
in the charger, then will go on and remain on while the battery is charging.
NOTE: The COM400CC uses “smart batteries.” That means each battery will retain charging
information that will cause it to automatically discharge completely before being recharged,
every tenth time it is placed in the charger. This will improve the battery’s performance and
life. While a battery is discharging, its red Charging light will blink on and off at 2 second
intervals.
When the battery is fully charged and ready for use, the red light will go off and the green
Ready light adjacent to the battery will go on.
To remove fully charged batteries from the battery charger, push the battery from the end
near the status lights. Store fully charged batteries in the storage ports until you need them.