User's Manual

27
VII. ACCESSORIES AND OPTIONAL EQUIPMENT
The following optional equipment is available for use with your System 400.
To order any of these products, call the HME Sales Department at [phone].
Equipment Model Number
COMMUNICATOR COM400BP
®
COMMUNICATOR COM400CC
®
COMMUNICATOR COM430BP
®
Battery (NiCd) for COM400 or COM430BP COMMUNICATOR BAT400
®
Battery (NiMH) for HS30 BAT30
Battery (NiMH) for COM400CC BAT900
Headset for COM400BP
HS9-90
Headset for COM400CC HS9LT
Headset for COM430BP HS30
Headset Earmuff no model number
Earpiece/Microphone HS4
Ultrasonic Vehicle Detector DU3
Vehicle Detector Board VDB101A
Vehicle Detector Loop (underground) VDL100
Message Repeater MR300
Remote Display R30
Ceiling Speaker MM100
Low-Profile Speaker with Volume Adjustment MM2500
Microphone DM1
Speaker SP2000A
Mode Switch (dual lane) MS1000
VIII. FCC NOTICE
HME wireless radio frequency systems are type-accepted in the United States under Part 90 of the
Federal Communications Commission (FCC) Code of Federal Regulations, and type-approved in
Canada by Industry and Science Canada. Because licensing depends on the system’s application,
it is the user’s responsibility to apply for a license from the FCC in the U.S. and its possessions, or
from Industry and Science Canada in Canada and its territories. Licensing requirements vary from
country to country. Contact your local licensing agency for specific requirements.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communication. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by HM Electronics, Inc. could void the users
authority to operate this equipment.