User's Manual

Figure 28. AC30 Battery Charger

Charging HS30 Batteries in the AC30 Battery Charger:

Place up to four HS30 batteries in the charger to charge at the same time, as

shown in Figure 28. A few seconds after each battery is placed in the charger,

the red CHARGING light on the panel adjacent to the battery will indicate the

battery charging status. See the CHARGING LIGHT STATUS TABLE for a

detailed explanation of what is happening. When a battery is fully charged, the

green READY light on the panel adjacent to it will light. (approximately 2.5

hours) It can then be placed back into a HS30 Headset.

CAUTION: Do not remove batteries from the charger until the green

READY light is lit, or the charger will reset and the charge

cycle will begin again.