User Manual

Hereby, HM Electronics, Inc. declares that the DX100 is in compliance with the essential requirements and other
relevant provisions of R&TTE Directive 1999/5/EC.
This product operates in the 2400 to 2483.5 MHz frequency range. The use of this frequency range is not yet
harmonized between all countries. Some countries may restrict the use of a portion of this band or impose other
restriction relating to power level or use. You should contact your Spectrum authority to determine possible restrictions.
MANDATORY SAFETY INSTRUCTIONS
FOR INSTALLERS AND USERS
Use only manufacturer or dealer supplied antennas.
The Federal Communications Commission has adopted a safety standard for human exposure to RF (Radio Frequency)
energy, which is below the OSHA (Occupational Safety and Health Act) limits. These instructions also meet Industry
Canada RSS-GEN 7.14
The term “IC:” before the certification number signifies that the Industry Canada technical specifications were met.
WS200 Antenna minimum safe distance: 7.9 inches (20 cm) at 100% duty cycle.
WS200 Antenna gain: This device has been designed to operate with an antenna having a maximum gain of up to 0dBi.
The required antenna impedance is 50Ohms.
WARNING: Maintain a separation distance from the base station transmit antenna to a person(s) of at least 7.9 inches (20
cm) at 100% duty cycle.
You, as the qualified end-user of this radio device must control the exposure conditions of bystanders to ensure the
minimum separation distance (above) is maintained between the antenna and nearby persons for satisfying RF exposure
compliance. The operation of this transmitter must satisfy the requirements of Occupational/Controlled Exposure
Environment, for work-related use. Transmit only when person(s) are at least the minimum distance from the properly
installed, externally mounted antenna.