User Manual

PC850 is a Microsoft Windows

application which enables the user to make all PRO850 base station and

beltpac configuration settings on a PC and save the settings to files. An RS-232 interface cable must be used to

connect the PRO850 base station to the PC in which PC850 software is installed.

PC850 Installation

NOTE: Before installing PC850, close all other programs that are open.

To install PC850 under WindowsJ 95, WindowsJ 98, WindowsJ NT4.0 Svc Pac 3, WindowsJ 2000,

WindowsJ ME or Windows

XP, follow the instructions below.

1. Insert the CD into a selected CD-ROM drive.

• If the CD-ROM drive is set for AutoPlay, the PC850 installation will begin automatically.

Skip steps 2 and 3.

• If the CD-ROM drive is not set for AutoPlay, continue with steps 2 and 3 below.

2. Under Windows Explorer or File Manager, double click on the CD-ROM drive where the CD is inserted.

3. Double click on the setup.exe file, and the PC850 installation will begin.

Proceed as instructed on the installation screens. When the installation has been completed, select Finish to end

the installation process.

SECTION 4. PC850 SOFTWARE

Minimum Requirements for Use of PC850 Software

• IBM compatible PC with a Pentium

microprocessor

• Minimum of 32 megabytes RAM

• Minimum of 100 megabytes available hard disk space

• One available RS-232 serial port or a modem interface

• Serial interface cable appropriate for your PC (See Section 2.1)

• Microsoft Windows

95, Windows

98, Windows

NT4.0 Svc Pac,

Windows

2000, Windows

ME or Windows

• Familiarity with Windows

operating system

• Internet Explorer 4.1 or later

To install PC850 for Windows NT/2000, you must be a System Administrator. For Windows NT/2000,

if you have installed this product for multiple users, you may give authorization to all PC850 users at

once. To do this, log into the computer as System Administrator and install PC850 according to these

instructions. After successful installation, all users will have access to PC850. To be able to run PC850,

each user must have “Read, Write and Execute” permission for the ProgramFiles\HME\PC850 directory.