User Manual

Headset Output Mixing (continued):

Select HSL (headset left) or HSR (headset right),

then select the box(es) next to RX1-RX4 to enable

input. Use the control knob to adjust output level in

0.25dB or 2.25dB increments for the desired mix.

Check these boxes only if you want receiver audio

continuously fed to the Headset Output. Leave

them unchecked for normal operation.

Place the cursor to the left of the bar below HS:dB

and use the control knob to adjust the overall

headset audio output level in 1.5dB increments.

Alert Settings:

To set the Alert relay to close under the desired

conditions select any or all of the boxes by

moving the cursor to a box and pressing the

ENTER button. If no boxes are checked, the alert

relay will not be used.

NOTE: Error indicates the base station detects

an error condition. Over Temp indicates the

internal base station temperature is excessive.

BP Low Battery indicates that any beltpac in the

system has a low battery. BP Button indicates

any beltpac button that has been programmed as

an alert button.

Page Settings:

To activate the page feature, select Enable and

press the ENTER button.

NOTE: If the page relay is not enabled and a

beltpac page button is pushed, a reject tone will be

heard in the beltpac’s headset.

Synchronize Base Station Settings:

To configure synchronized base station settings,

press the ENTER button.

NOTE: This only pertains to systems with master

and slave base stations. All beltpac settings are

done in the master base station. Synchronizing

the slave bases will cause all settings from the

master base station to be transferred to the slaves.