User Manual

7
Figure 6.
Battery replacement
5. Configuration Settings
• With the power already on, press and hold the Power button
and press the
B button. NOTE: You must press the B button within 2
seconds after pressing the power button, or you will turn
the power off and have to begin again.
• You will hear “Configuration” in the headset.
• Select the desired configuration setting described in “a ”
or “b ” below.
• When finished, press and release the B button to exit the
configuration-settings mode. You will hear “Power on,
lane (one or two) ” in the headset.
• Configuration settings will remain in effect until you
change them again.
a. Hands-free On/Off
• Touch and release the Volume-down button — you will hear
“ Hands-free on. ”
• Touch and release the Volume-down button again — you
will hear “ Hands-free off. ”
• You will continue to hear “Hands-free on ” or “Hands-
free off ” messages alternating each time you touch and
release the Volume-down button.
The last hands-free on/off message heard will be
selected when you exit the configuration-settings mode.
b. Single/Dual Lane
• Touch and release the A1 button — you will hear
“ Single lane. ”
• Touch and release the A1 button again — you will hear
“ Dual lane. ”
• You will continue to hear “Single lane” or “Dual lane ”
messages alternating each time you touch and release the
A1 button. The last single/dual lane message heard will
be selected when you exit the configuration-settings mode.
6. Battery Removal and Replacement
If you hear “Headset Battery Low ” in the headset, its
battery needs to be replaced and recharged. HS500 batteries
need be recharged after 8 to 9 hours of normal use.
a. Battery Removal
• Push the battery-release latch upward.
• Pull the battery out from the top.
b. Battery Replacement
• Place the end of a battery into
the battery
compartment, with its metal
contacts
downward.
• Press the top of a battery into
the battery
Figure 5.
Battery removal
Batte
ry
relea
se
lh