User Manual

3
Base Station External Features
Front –
• POWER light is on when the base station has power.
• MESSAGE RECORD light is on RED when the base station is
ready to record
message #1 for the message repeater, and blinking RED while
message #1 is being recorded. It is on GREEN when the base
station is ready to record message #2 for the message
repeater, and blinking GREEN while message #2 is being
recorded. The MESSAGE REPEATER button must be pushed IN.
• RECEIVE light is on during channel-A and channel-B
transmissions, and is used for troubleshooting.
• “ A ” light is on during channel-A transmission.
• “ B ” light is on during channel-B transmission.
• VEHICLE light is on when a vehicle is present in the drive-
thru lane or when the system is in vehicle-detect override.
Bottom –
• PUSH FOR RECORD MODE button must be pushed IN and released
once to prepare the base station to record message #1 for
the message repeater, or pushed IN and released twice to
record message #2.
• MESSAGE REPEATER button must be pushed IN to use the
message repeater, OUT when the message repeater is not
being used.
• SPEED TEAM button must be pushed IN for speed-team
operation, OUT for normal drive-thru operation
• VEHICLE DETECTOR button must be pushed and left IN to
override a vehicle detector; to reset vehicle detector,
push IN and leave IN for 5 seconds, then push again and
leave OUT for normal vehicle detection.
Left Side –
• WIRED/WIRELESS button must be OUT when using the wireless
System 500, IN when using a wired backup system.