User's Manual

BELTPAC SETUP AND REGISTRATION

The first time you operate the DX200 system, you must register each Beltpac for use with a specific base

station. The base station will then recognize all registered Beltpacs when their power is on, and will know the

difference between them and other electronic equipment operating on the same frequencies. If a Beltpac is added

or replaced later, the new one must be registered and the old one remains in memory. A maximum of 15

Beltpacs can be registered to a single base station at one time.

Set Up Beltpacs

Before registering them, set up all Beltpacs as follows.

Step 1. Insert a fully charged battery in the

Beltpac, with the metal contacts on

the end of the battery inserted first.

Press it in until it snaps.

Step 2. Place the Beltpac in the pouch.

Step 3. Plug the headset cable connector into the Beltpac.

Beltpacs must be within 6 feet (1.83 meters) of the base station while you are registering them. Be certain the

base station power is on, and each Beltpac you are going to register is turned off before you begin. Beltpacs that

are already registered can be on or off.

Step 1. Put the headset, of the Beltpac being registered, on your head.

Step 2. Press the REGISTER BELTPAC button on the front panel of the base station (#7 on base station front

panel illustration).

• The REGISTRATION STATUS display (#6 on base station front panel illustration) will show a

small “o” for open.

NOTE: If you wait too long before going on to Step 3, the base station will go out of the registration

mode and you will have to repeat Step 2.

Step 3. Press and hold the ISO button on the Beltpac while you press and

release the PWR (power) button to turn the unit on, then release the

ISO button. This will cause the Beltpac to enter the registration mode.

• The two power lights at the corners of the Beltpac near the IC

and ISO buttons will begin blinking red, then will blink green

two or three times and go off.

•

Wait! There may be a short delay.

If registration is successfully completed:

• A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, Registration

complete, …”

• After a delay of up to 15 seconds, the REGISTRATION STATUS display will show the ID number assigned

to this Beltpac for about 10 seconds.

NOTE: ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.

• The power light on the Beltpac, next to the IC button, will remain on steady green.

• Repeat Steps 1 to 3 above for each Beltpac to be registered.

Ste