User's Manual

BASE STATION SETUP

The following description is for a basic, stand-alone DX200 system setup. Connections with 2-wire and 4-wire

intercoms, and other auxiliary equipment are described in the INTERCOM AND AUXILIARY EQUIPMENT

SETUPS on pages 7 and 8.

Equipment Connections

Rear Panel

Front Panel

The numbers (#

) below refer to items on the illustrations above.

Step 1. Connect the two enclosed antennas to the antenna connectors (#1 and #2) on the rear panel of the base

station. Position the antenna at the 0° ANTENNA connector (#1) vertically. Position the antenna at the 90°

ANTENNA connector (#2) horizontally, pointing to the left as indicated on the panel. Turn the sleeve on

each of the antenna connectors clockwise to tighten them securely in place.

Step 2. Plug the connector at the end of the AC power supply cord into the 12-14VDC power connector (#3) on the

rear panel of the base station. Turn the nut on the cable connector clockwise to secure it to the base station.

Plug the large female connector at one end of the AC power cord into the power supply. Plug the other end

of the AC power cord into an electrical outlet.

Step 3. Connect a grounding wire from #4 to an earth ground.

Step 4. Plug a headset into the HEADSET connector (#8) on the front panel of the base station.

Step 5. Press the POWER switch (#5) to turn on the base station. The red light on the switch should go on.

1 2 3 4

8 5

6 7