User's Manual

APPENDIX A:

BATTERY CHARGER 230 VOLT AC ADAPTER

CONNECTIONS

If your DX200 will be used outside the U.S.A., where a 230 Volt AC adapter is required for your battery

charger, connect the AC adapter to the battery charger as follows.

Step 1.

Connect an electrical plug to the wires on the power cable according to color codes.

(Brown = live, Blue = neutral, Green with yellow stripes = ground)

Step 2.

Plug the other end of the power cable into the receptacle on the AC adapter.

Step 3.

Remove the spade lugs from the brown and blue wires of the battery charger cable and cut the green/yellow

wire as short as possible. No ground wire will be used. Cut the connector off the AC adapter output cable.

Strip enough of the insulation from the wires of both cables so they can be spliced. Splice the wires from

the AC adapter cable to the “AC” wires of the battery charger cable. Cover the splice with electrical tape or

shrink tubing.

Step 4.

Plug the electrical plug into an AC electrical outlet.