User's Manual

INTERCOM AND AUXILIARY EQUIPMENT SETUPS

Rear Panel

Front Panel

The numbers (#

) below refer to items on the illustrations above.

2-Wire Intercom

Step 1. If using a 2-wire intercom, plug it into the base station at #3 or #5, depending on whether a male or female

connection is required.

Step 2. Depending on whether you are using a Clear-Com® or RTS® compatible 2-wire intercom system, position

the CLEAR-COM / RTS TW button (#1) as follows:

In position = RTS® Mode Out position = Clear-Com® Mode

Step 3. If you selected RTS TW, position the RTS CHANNEL select button (#2) to the desired channel as follows:

Out position = Channel 1 In position = Channel 2

Step 4. Press the 2W/4W button (#25) on the front panel of the base station. The 2W and 4W lights (#15) above the

button should go on. Turn the Beltpac power on. Press the IC button on the Beltpac pressed and speak into

the headset microphone. You will hear a delayed echo of your voice. Adjust the NULL control (#4) with a

small screwdriver while you are speaking, until the echo is eliminated.

4-Wire Intercom

Step 1. If using only a 4-wire intercom, plug it into the 4-WIRE connector (#6).

Step 2. Press the 4W ONLY button (#26). The 4W light (#15) above the button should go on.

Step 3. Adjust the 4-wire intercom send and receive levels with the SND and RCV controls (#16).

Pin designations for the RJ45

4-WIRE connector are as follows: Pins 1, 2, 7 & 8 = N/C

Pin 3 = Intercom Out +

Pin 4 = Intercom In +

Pin 5 = Intercom In –

Pin 6 = Intercom Out –

NOTE: If no 2-wire intercom will be used, you must

press the 4W ONLY button (#26), or a squeal will be

heard in the headsets.

1 2 3 4 5 6 7 8 9

23 24 25 26 27 28 29 30

10 11 12 13 14 15 16 17 18 19 20 21 22