User's Manual

8.8.3 Setting system sync mode
Use this setting to make antenna synchronization readings.
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Settings > Admin Options. You will
be prompted to enter a four digit code. The default code is 4632.
3) Select System Sync.
4) Use either rotary control to select the antenna group to synchronize.
8.9 Setting the listen again option
Use this setting to configure an option to allow you to play back an incoming message. When
Listen Again is active, if you tap the Menu key on the beltpack, the last received message is
played back. You can select the length of the recorded message, and also how long the
message is stored on the beltpack before automatic deletion. To play back a recorded
message, press the Menu button.
To select the length of the recording:
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Settings > Listen Again Opt >
Recording Time.
3) Use either rotary control to select a value between Off and 15 seconds.
To determine how long the message is stored:
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Settings > Listen Again Opt > Auto
Delete Time.
3) Use either rotary control to select a value between Off and 240 minutes.
8.10 Accessing beltpack information
You can access a list of beltpack information, including battery and fault-finding information.
1) To enter the beltpack menu, press and hold the Menu key.
2) Use the rotary and Menu Select keys to select Information.
You can read the following information:
Item
Value
Beltpack role Role name
86
FreeSpeak II User Guide