User's Manual

3) Select ‘CALLS’ from the menu. The call destination menu will be displayed.
Figure 6-30 Port call menu
4) Use the setup/enter encoder to scroll through the available ports and select the
required destination port. It is possible to select the source port as the call destination
to create an audio loopback system. This may be used for audio testing purposes.
Figure 6-31 Port destination select menu
5) When the port is selected, the user is returned to Selected Port Menu for Calls
(Step 2). The screen will flash momentarily to indicate that the port change has been
accepted by the system.
6) The port destination can be cleared by repeating the process and selecting the
‘NONE’ entry.
If one of the headset ports (HDSTA, HDSTB) is selected the port menu is different in that
‘KEY’ is displayed rather than ‘CALL’. This indicates than in order to trigger an auto route from
the headset to the chosen destination the key on the Base station front panel should be used.
7) From the MAIN menu, select ‘PORTS’. A menu of the available audio ports is
displayed.
Figure 6-32 Available audio ports menu
8) Select the head set for which the call destination is to be set. The menu for the
selected headset will be displayed.
Figure 6-33 Selected port menu for calls
9) Select ‘KEY’ from the menu. The audio destination menu will be displayed.
60
FreeSpeak II User Guide