User's Manual

10.4.2 Registering beltpacks using the micro USB cable
When beltpacks are first registered with a Base station they must be paired with the Base
station using the procedure below. You can now edit the beltpacks using the Configuration
Editor or the Base station front panel menus.
1) First load or retrieve a configuration file. See 10.1 Loading configurations.
2) Connect the beltpack to the PC using the standard beltpack micro USB cable and
power it on.
3) From the BP ID list, select the serial port connected to the beltpack
4) From the Name field, select a beltpack slot. See 10.4.1 Selecting the beltpack to
register or edit.
Note: You can also change the name of the beltpack by over typing the value in
the Name field.
5) Select Register. The Configuration Editor now sends the system number and DECT
carrier mask information to the beltpack, and also stores the serial number of the
beltpack in the Base station configuration.
If the program connects successfully with the beltpack, the BP ID field displays its ID
number.
Note: You can reassign the beltpacks to different slots on the same Base station
using the Configuration Editor or the Base station front panel.
You can also pre-register spare beltpacks and then add them to the system
later by entering the beltpack serial number into the configuration editor or
the Base station.
10.4.3 Viewing beltpack registration information
1) To view a summary of the labels and serial numbers of the beltpacks, click
Overview. The following screen is an example:
103
FreeSpeak II User Guide