User's Manual

visible. This shows that the beltpack has been previously registered with the
system which will recognise it.
5) Enter the four digit pairing code for the system using both rotary controllers and the
menu select key (D). The default code is 0000.
6) Select an available role from the list displayed on the beltpack.
7) The beltpack is now paired and ready for operation.
8) If required, the next beltpack can now be registered (step 3). You may need to re-
enable registration mode before registering another beltpack. Registration mode has
a two minute inactive time-out.
10.4 Configuring beltpacks
From the Configuration Editor, you can use the Beltpacks tab to:
• Register beltpacks with the Base station
• Edit key assignments
• Change input and output levels.
10.4.1 Selecting the beltpack to register or edit
1) From the Name list, select a beltpack slot.
The Name list contains all the beltpacks and their serial numbers.
2) In the Name field, enter an ID for the beltpack. Enter a maximum of five characters.
Note: You can also use the Next and Previous buttons between the Name and
Serial Num fields to step through the beltpacks.
3) In the Serial Num field, enter the serial number of the beltpack. The beltpack serial
number is a four digit number on a label on the back of the beltpack.
Figure 10-7 Beltpack Label
102
FreeSpeak II User Guide