Installation Guide
© 2020 HM Electronics, Inc. All rights reserved.
5
REGULATORY COMPLIANCE
Applicant Name: HM Electronics, Inc.
Applicant Address: 2484 Whiptail Loop, Carlsbad CA 92010, United States
Manufacturer Name: HM Electronics, Inc.
Manufacturer Address: 2484 Whiptail Loop, Carlsbad CA 92010, United States
Country of Origin: USA
Brand: HME
Caution: All products are compliant with regulatory requirements detailed in this document when the user follows all
installation instructions and operating conditions per HME specifications.
Caution: Use of accessories and peripherals other than those recommended by HME may void the product’s compliance
as well as the user’s authority to operate the equipment.
Caution: All products are designed for use with the standard, integral or dedicated (external) antenna(s) that are shipped
together with the equipment. Any product changes or modifications will invalidate all applicable regulatory certifications
and approvals.
Caution: The use of software or firmware not supported/provided by HME products may result that the equipment is no
longer compliant with the regulatory requirements.
Warning: The power adaptor is the equipment’s disconnection device. The power outlet must be
located nearby the equipment and its access must be easy.
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communication. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by HME could void the user’s authority to operate this equipment.
FCC/IC/EC RF EXPOSURE WARNING
This product complies with FCC/IC/EC radiation exposure limits set forth for an uncontrolled environment.
Produits HME sont conformes aux limites IC d’exposition aux rayonnements définies pour un environnement non contrôlé.
This product may not be co-located or operated in conjunction with any other antenna or transmitter.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou
transmetteur.
To comply with FCC/IC/EC RF exposure requirements, this unit must be installed and operate at least 20 cm (8 inches)
from any person.
Produits HME doivent être installés et utilisés avec distance minimum de 20cm entre le radiateur et votre corps.
INDUSTRY CANADA COMPLIANCE STATEMENT
Avis de conformité à la réglementation d’Industrie Canada
Cet appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation
est soumise aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d’interféence, et
(2) cet appareil doit accepter toute interféence radioéectrique subie, mêe si l’interféence est susceptible d’en comprom-
ettre le fonctionnement.
Cet éetteur exempt de licence est éuipéd’une antenne intéré. Cet éetteur exempt de licence n’est pas autoriséàfonctionner
avec une autre antenne.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou
transmetteur.
Cet appareil numérique de la class[A] est conforme à la norme NMB-003 du Canada.
This Class[A] digital device complies with Canadian ICES-003.
KOREAN NOTICE
EUROPEAN UNION (CE MARK)
The CE marking indicates compliance with the following directives and standards, whenever applicable to the product in
question.
Directives:
- Radio Equipment Directive 2014/53/EU
- Electromagnetic Compatibility Directive 2014/30/EU
- Low Voltage Directive 2014/35/EU
- RoHS Directive 2011/65/EU and 2015/863/EU
Standards:
- EN55022/EN55032
- EN55024/ EN55035
- IEC/EN62368-1
- EN300328
- EN301489
- EN50581
Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
Class A equipment (commercial broadcasting and
communication equipment)
This device has been tested for conformity for us in a
work environment. In a domestic environment, radio
interference may occur.