User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
Display
l
Screen Brightness. High, Medium (default), Low, Very Low
l
Screen Dimming. The screen will dim to Very Low when there is no activity. Timeout time:
1,2 (default),3,5,10 or 15 minutes.
8.1.3 2W Audio (A,B)
Configure power settingsfor 2-wire audio sources and perform nulling.
l
Interface - power settings
l
Power detected? Yes/No
l
Power Enabled/Disabled (default = disabled)
l
Mode Clear-Com/RTS (default = Clear-Com)
l
2W A and 2W B.Press the rotary control (Start) to perform autonull. Nulling is only
available if power is detected.
8.1.4 2W Audio (C,D)
See 2W Audio (A,B)
8.1.5 Discovery
l
Discover FSII TCVR.
l
Lists all FSII transceivers visible on the network. Select the transceiver you wish to
register (third rotary). Select Register and push the rotary (fourth rotary) to begin
the connection sequence.
l
Discover FSE TCVR.
l
Lists all FS Edge transceivers visible on the network. Select the transceiver you
wish to register (third rotary). Select Register and push the rotary (fourth rotary) to
begin the connection sequence.
Deregister will remove the transceiver from the system. You will only see the Deregister option
if the transceiver has been registered.
8.1.6 Transceiver
Lists all registered transceivers. You can view and edit Label and Cable Comp here. Pushing
the fourth rotary will open the onscreen keyboard (touchscreen). [OK] when done.
l
FSII IP. Version, Label.
l
FS Edge. Version, Label.
Page 81