User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
There are a number of configuration and monitoring functions that are available from the front
panel.
Some common tasks you might perform from the front panel menus are:
l See/configure the Arcadia Central Station IP address
l See the default CCM password
l Null your 2-wire audio sources
l Reset the Arcadia Central Station to factory settings
l Reset the CCM password
To enter the Arcadia Central Station menu system, press the Menu button on the front panel.
Navigate through the hierarchical menu using the rotary controllers. To select or commit a menu
item, press the rotary encoder next to it.
To exit the menu system, press the Menu button again, or leave the device to time-out of menu
mode (17 seconds).
8.1 Front Panel Menus
8.1.1 Audio Settings
Headset Limit. This allows the user to set the headset limiter for the front panel headset.
l
-12 dB to +8 dB/ OFF
HS Mic Type
l
Dynamic (default)
l
Electret
Sidetone Gain
l
-15 dB to +8 dB (-12 dB default)
Sidetone Control
l
Tracking (default)
l
Non-Tracking
l
Disabled
8.1.2 Host Settings
Host Name. Pushing the fourth rotary will open the on screen keyboard to allow the user to
enter a new name for the device (touchscreen). [OK] when done.
Page 80