User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
The Hardware page of the CCM is where you will initially set up your system. It gives an
overview of the FS Edge Arcadia Central Station and the transceivers, beltpacks and ports that
are present. From this page, you can use the Add Resource button to:
l View a list of both discovered and registered transceivers.
l Add any discovered transceivers to the system
l Remove any registered transceivers from the system
l Register beltpacks to the system
In the Hardware Resources page you can:
l Adjust settings on interface ports
l
Configure network information (LAN ports and IP addresses) for the Arcadia Central
Station and transceivers
l Upgrade firmware
l Find and change administrative details, such as
l Administration PIN
l OTA System ID
l FreeSpeak Edge Wireless regions
l Change or set FreeSpeak Edge 5 GHz channels
l FreeSpeak II battery types and PINs
5.4 Configuration page
Page 44