User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
l IP addresses can be configured statically under Hardware > Resources > Network in
the CCM.
l For information on the 5 GHz transceiver (status and connection indicators) see the Edge
Transceiver Quick Start Guide available from the FreeSpeak Edge Knowledge Center
l Connection status indicators on the FreeSpeak II IP transceiver are the same as the Edge
transceiver (no channel scan).
l For PoE to the transceivers you will need a PoE enabled network switch.
4.2 Arcadia Central Station LAN Configuration Rules
Note: Do not plug any two LAN ports into the same LAN or VLAN. This could lead to a broadcast
storm.
Note: Resetting the AES67 IP address will cause the Arcadia Central Station to reboot.
l
AES67
l
AES67 should not be on the same subnet as Management unless they are on the
same LAN port (rear port)
l
AES67 cannot be on the same LAN port as DANTE primary or secondary
l
Static IP
l
The static IP addresses cannot be in link local range: 169.254.xxx.xxx
l
The static IP addresses cannot be in the reserved range: 10.0.0.0-7
l
The static IP addresses cannot be in the LQ tunnel range 172.23.xxx.xxx
Page 38