User's Guide
Table Of Contents
- 1 Introduction
- 2 Installing Arcadia Central Station
- 2.1 Front Panel Connectors, Controls and Indicators
- 2.2 Intercom Touchscreens
- 2.3 Rear Panel Connectors and Indicators
- 2.4 System Powering
- 2.5 Clear-Com Ethernet Cable Recommendations
- 2.6 Stage Announce and Program Feed
- 2.7 Set the Arcadia Central Station IP address
- 2.8 Save and Restore System Configuration
- 2.9 Reset to Default
- 2.10 Example Applications
- 3 Connecting to other systems
- 4 Network Setup
- 5 Core Configuration Manager (CCM) walkthrough
- 6 CCM configuration
- 6.1 Setting up the Arcadia Central Station
- 6.2 Adding IP Transceivers (FS Edge, FS II 1.9, 2.4)
- 6.3 Registering beltpacks
- 6.4 Viewing and adding Channels
- 6.5 Viewing and Adding Members to Groups
- 6.6 Channels or Groups?
- 6.7 Creating and Editing Roles
- 6.8 Set up GPIOs and Logic Events
- 6.9 Monitoring Your System from the CCM
- 7 Security
- 8 Configuring from the Front Panel
- 9 Spare parts
- 10 Terminology/glossary
- 11 Front Panel Menu Reference Tables
- 12 Specifications
- 13 Pinouts
- 14 Regulatory compliance
User Guide | Arcadia Central Station
2.8 Save and Restore System Configuration
Clear-Com recommends that you make a backup of your system configuration using the Save
option that is available in the CCM and the front panel menu system.
2.8.1 Save System Configuration in the CCM
The Save and Restore options are available in the CCM top navigation bar.
When you click Save, all system configuration; channels, roles and network details are saved to
a file (.cca) on your computer. The progress of this Save is shown in the notification bar on the
front panel.
2.8.2 Save System Setup in the Front Panel Menus
1.
Insert a USB drive into the USB connector on the front of the Base.
2.
Press the Menu button.
3.
Using the rotary controllers, navigate to Administration>Settings>Save.
4.
Push the 4th rotary controller. System setting are saved to the USB drive. The progress of
this Save is shown in the notification bar on the front panel.
2.8.3 Restore System Configuration
Your system configuration can be restored to the Arcadia Central Station at any time using the
Restore button in the CCM and also from the front panel menu system.
On Restore the saved configuration is reapplied to the Arcadia Central Station. The following
aspects of the configuration are optionally restored:
l
Network settings (IP addresses)
l
OTA system ID.
You do not get these options when restoring by USB directly to the Arcadia Central Station. If
you want to restore system settings taken from different Base Stations, you must use the CCM
Restore option, as restoring directly from the Arcadia Central Station in this situation would
overwrite network and OTA system ID and IP and wireless ID conflicts.
2.9 Reset to Default
Your Arcadia Central Station can be reset to default settings either from the Base front panel
menus or from the Core Configuration Manager (CCM).
Page 16