User's Manual

78
6.7 Speed-Team Operation
Speed team operation is used during high-volume times. An order taker wearing a
headset relays orders from outside into the store, using button A1, A2 or B.
Note: Speed teams are only used in single or dual-lanes, not in tandem drive-thrus.
CAUTION: With Speed Team ✔ (on), many base station functions will be
disabled. Vehicle arrival tones and the customer’s voice will not be heard
during Speed Team operation. For normal order taking, the Speed Team
setting should be − (off).
To start speed-team operation, you must press the Menu button on the base station
LANE STATUS display, and then press the Operator mode button on the MAIN MENU
display. On the OPERATOR MODE display, press the Activate Speed Team button to
select ✔(on). To change back to normal operation, return to the OPERATOR MODE
display and press the Activate Speed Team button to select −(off).
Select Ext only if speed team will be activated from a remote switch connected to
the base station. See Figure 24.
6.8 Wired Backup System
In order to use a wired backup system, there must be a Switcher Board (optional) in
the base station. Open the base station, and look for the board shown in Figure 23.
If there is no Switcher Board, a wired backup system cannot be used. If there is a
Switcher Board, place the S2 switch in the IN position to use the wired backup
system. When using the EOS|HD, leave the S2 switch in the OUT position.
6.9 Message Center Operation
To record messages and set up times and locations for them to be played, refer to
section 4.5.3.
Note:
In multiple-lane
operations, Activate
dedicated mode will
also appear on the
OPERATOR MODE
display.
See
Appendix for
explanation.
Figure 23. S2 switch on Switcher Board