User's Manual

69
4.5.8 Installer Setup
See Section 4.2 for Basic Installer Setups and Section 4.3 for Advanced Installer
Setups.
4.5.9 Network
See Section 4.4 for Network settings.
4.5.10 Diagnostics
Only press the Diagnostics button if you experience a problem with EOS|HD operation
and have to call HME Technical Support. The Technical Support representative will
guide you through the automated diagnostics. If this is necessary, select Menu on
the base station STATUS display and then press the More button on the MAIN
MENU. On the ADVANCED MENU, press the Diagnostics button, and then select the
test requested by the Technical Support representative.
If requested, press the More button on the DIAGNOSTICS display for additional
diagnostics.
4.5.11 Early Warning Setting
An external vehicle detector can be used with the EOS|HD to give a pre-warning
signal when a vehicle enters the drive-thru area. To set up a pre-warning signal, first
install the external vehicle detector at the desired detection point then connect its cable
to the base station audio circuit board according to the appropriate wiring diagram in
Figures 26 through 36.