User's Manual

4.3 Advanced Installer Setups

To perform the following advanced installer setups, press the More button on the

INSTALLER SETUP display to access the ADVANCED INSTALLER SETUP display.

4.3.1 Phone

If a telephone is connected to the base station, to be used for telephone orders, the

system must be set up for telephone operation. To do this, on the ADVANCED

INSTALLER SETUP display press the Phone button. On the PHONE SETTINGS

display, select ✔(on). If a telephone will not be used, select −(off).

To adjust the telephone outbound or inbound audio level, press the Audio Out or

Audio In button and then press the + or − button to set the desired level.

Note: When setting the Phone function to ✔(on), you must also select a Phone Headset to

receive the calls. See Phone Headset under Store Settings, section 4.5.7. An optional

Telephone Interface is also required. See Figure 36, Optional Equipment Wiring Diagram.

4.3.2 Audio Fidelity

If you are installing a new base station where all existing headsets are all either Non-HD

or HD Audio (default), you must select the respective audio fidelity. To do this, select

Audio Fidelity on the ADVANCED INSTALLER SETUP display and then, on the

SELECT AUDIO FIDELITY display, press the Select Fidelity button to make the

appropriate selection. If you select Automatic audio fidelity, the fidelity of the base will

be set by the first headset registered.

To save the setting, press the Back button.

CAUTION:

Making this change will require re-registering all headsets.