User's Manual

25
4.2.3 Speaker Post
Select Speaker post on the INSTALLER SETUP display to access the SPEAKER
POST display, to make the necessary outside speaker/microphone settings.
Press the Duplex button to select Full or Half duplex operation.
Press the AVC button to select ✔(on) or −(off) for AVC (Automatic Volume Control).
When there is excessive outside noise, the level of the order taker’s voice in the
speaker will be adjusted up. When it is quiet in the drive-thru area, the level will be
adjusted down.
Press the Microphone button to make the following outside microphone settings.
To save the setting, press the Back button.
4.2.4 Configure Menus
The Configure menus setting provides security for Message Center settings, so no one
other than managers can make changes to them. To do this, select Configure menus
on the INSTALLER SETUP display.
On the CONFIGURE MENUS display, press the respective button to highlight ✔(on) or
−(off). If − is selected, that category of messages will be deleted from the MESSAGE
CENTER MENU, thereby not allowing anyone access to those Message Center settings
unless a manager resets the respective CONFIGURE MENUS setting to highlight ✔.
To save the setting, press the Back button.
Select the type of microphone installed in
the speaker post by pressing the
Microphone button repeatedly until that
microphone is highlighted.
Select the typical distance from the
microphone to the vehicle in the drive-thru
lane by pressing the Distance to vehicle
button repeatedly until the correct distance
is highlighted.
Note:
In multiple-lane
configurations, the
SPEAKER POST
display will be divided
by Lanes. Settings will
be similar to those
shown for single lane.