User's Manual

4.2 Basic Installer Setups

To access the Installer Setup mode, you must have an installer password. If you have

an installer password, proceed as follows:

Press the Menu button on the LANE STATUS display to access the MAIN MENU.

Press the More button on the MAIN MENU to access the ADVANCED MENU.

Press the Installer setup button on the ADVANCED MENU to access the ENTER

INSTALLER PASSWORD display.

Enter the first character of the 4-digit password

in the highlighted box in the Enter Password

field by pressing the + button to enter alphabetic

characters, or the − button to enter numbers.

Press the ► button to move the highlighted box

to the next position to the right. Repeat this

procedure until all 4 digits of the password are

entered, and then press the Continue button to

access the INSTALLER SETUP display.

Note: If you make a mistake, you can use the ◄ and ► buttons to move the highlighted

box to the necessary position and change the character entered there, or press the

Clear all button to clear all entries and start over.

If you enter an incorrect password and press the Continue button, you will see the

message “Invalid password, try again.” You can then re-enter the password. If you

enter an incorrect password 3 times, you will be locked out for 5 minutes, after which

you can try again.

You can now proceed to viewing and editing the following installer settings from the

INSTALLER SETUP display.

Note:

In multiple-lane configurations,

the INSTALLER SETUP display

includes Split B settings, as well

as other lane-configuration

settings which are not shown

here. These settings are

explained in the

Appendix.