User's Manual

20
If using the optional mounting brackets:
 Attach the brackets to the screw inserts on the sides of the speaker unit with the
two Phillips (crosspoint) screws provided as shown in Figure 21.
 Hold the front of the speaker centered against the speaker grill of the menu board or
speaker post. Mark the menu board or speaker post through the open holes in each
of the two mounting brackets on the speaker, and set the speaker aside. Drill holes
at the two marked spots, approximately the same size as the holes in the speaker
mounting brackets.
 Peel the paper off the self-adhesive gasket, and press the adhesive side of the gasket
against the front of the speaker in the position shown in Figure 19.
 Hold the speaker inside the speaker post or menu board, with the gasket against
the speaker grill and the holes in the mounting brackets over the two drilled holes.
 From outside the speaker post or menu board, place the two washers on the
enclosed security screws, and insert the screws through the two drilled holes.
Inside the speaker post or menu board, place the locking nuts on the security
screws. Tighten the nuts on the screws only enough to provide a good seal between
the gasket and the enclosure.
 Place foam around the sides and back of the speaker as shown in Figure 20.
Figure 21. Attach brackets to speaker