User's Manual

19
Foam
Speaker
grill
opening
Gasket
Pressure
Pressure
Foam
Speaker
cable
3.3.2 Install SP10 Speaker
 Strip approximately 1 inch (25.4 mm) of insulation from the end of the speaker
cable, and ¼ inch (6.35 mm) of insulation from each of the two cable wires, but do
not tin the wires. Connect the speaker cable wires to the connector plug as shown
in Figure 19.
 Insert the connector plug into the connector on the speaker as shown in Figure 19.
If not using the optional mounting brackets:
 Peel the paper off the self-adhesive gasket, and press the adhesive side of the gasket
against the front of the speaker in the position shown in Figure 19.
 Position the speaker inside the speaker post or menu board, with the gasket
centered against the inside of the speaker grill as shown in Figure 20. The cable
connector can be on the bottom or on either side. Align the opening in the gasket
with the grill opening.
 Remove both inserts from the molded foam enclosure and place the foam enclosure
around the speaker. Trim foam with serrated knife if necessary. Place removed foam
inserts behind speaker to provide pressure to speaker, to ensure a good gasket seal
against the speaker grill opening.
Speaker
cable
Connector
plug
Gasket
Figure 19. SP10 with gasket
and cable connector plug
Figure 20. SP10 in speaker post,
menu board or enclosure