User's Manual

58
4.5.4 Volume Adjustments
To adjust the volume of inbound and outbound audio, alert tones and message
repeater messages, on the base station LANE STATUS display, select Menu and then,
on the MAIN MENU select Volume adjust.
Press the button on the left side of the VOLUME MENU to select which volume you
want to adjust.
On the next display that appears, select which volume you would like to adjust, and
then use the + and − buttons to raise and lower the volume level.
Note: IN/OUTBOUND VOLUME settings adjust the level to and from the outside
speaker/microphone and the level of the outbound message from the Message Center.
If a volume is set to 0, that function is effectively turned off and no audio is heard at all.
The VEHICLE TONE VOLUME setting only adjusts the level of the alert tone heard in
the headsets.
To save these settings, press the Back button.
Note:
In multiple-lane
configurations, the
VOLUME MENU
display will be divided
by Lanes. Settings
will be similar to those
shown for single lane.