User's Manual

4.5 User Settings

User settings are for routine drive-thru operation. After you make the initial settings,

store personnel can change the settings as needed. To access the user settings, press

the Menu button on the LANE STATUS display. Routine user settings are accessed

from the MAIN MENU.

4.5.1 Vehicle Detection

To test the vehicle detector function by simulating a vehicle arrival at the speaker post

or menu board, select Menu on the LANE STATUS display and then press the

Vehicle detection button on the MAIN MENU.

Note: Be sure no car (or metal object) is present at the detection point.

Press the Mode button on the VEHICLE DETECTION display and select Override.

This will cause the vehicle alert tone to be played in headsets, followed by inbound

audio from the outside speaker. If enabled, a Customer Greeter message will also be

played. To return to normal operation, press the Mode button again and select Normal.

If you experience a problem with vehicle detection, such as the inbound audio not

shutting off from the outside speaker or no alert tone when a vehicle arrives, press the

Reset detector button on the VEHICLE DETECTION display, and then press the Yes

button to reset Vehicle Detector(s).

After Reset Completed appears and disappears on the display, press the Back

button to exit.

Note:

In multiple-lane

configurations, the

VEHICLE DETECTION

display will be divided

by Lanes. Settings will

be similar to those

shown for single lane.