User's Manual

38
 SMTP Port – The SMTP port is usually set to 25. However, some mail servers use a
different port. If it is necessary to change the SMTP port number, press the SMTP
Port button on the EMAIL SETTINGS display.
To edit the SMTP port number, on the EDIT SMTP PORT display, use the ◄ and ►
button to move the highlighted box, and then use the + and − buttons to change the
number in the highlighted box.
 Email Addresses –
The Source Address is pre-set to [e-mail].
This will be the address shown in the “From:” line on alert emails sent to selected
destinations. Destination email addresses are those to which alert emails will be
sent if Emails are set to ✔(on), on the EMAIL SETTINGS display.
To change the Source Address or Destination addresses, press the Email Addresses
button on the EMAIL SETTINGS display.
To enter or edit an email address, press the Source
Address or any Destination address button on the
EMAIL ADDRESSES display.
Use the Erase button to clear a current address.
Use the ◄, ►, ▲ and ▼ buttons to highlight a
character you would like to enter in the address, and
then press the Sel (select) button to enter it in the
highlighted box above. When you are finished, press
the Back button to save the address.