User's Manual

14
 If you are registering only one headset, press the
Register single button. After this single
registration has been completed, the base will
automatically exit the registration mode.
 If you are registering more than one headset,
press the Register multi (multiple) button and
continue registering each headset, one at a time.
When you have finished, press the Back button to
exit the multiple registration mode.
If you press the Clear inactive button, you will
unregister only those headsets that are turned off.
If you press the Clear all button, you will unregister
all headsets that are registered to the base station,
and the base station will automatically reset. You
will be given a warning and allowed to quit or
continue before registrations are cleared.
 On the HEADSET REGISTRATION display, press the Register headsets button.
 On the TO REGISTER HEADSETS display, follow the instructions in the box.
When each registration is successfully completed:
 The ID number assigned to this headset will be shown. ID numbers are assigned
sequentially as 0 thru 9, A, B, C, D and E.
 The power light on the headset will remain on steady green.
 When you have finished registering headsets, press the Back button to exit the
registration mode. You can continue pressing the Back button until you return to
the MAIN MENU or LANE STATUS display.
If you have any problems registering the headsets:
In the USA, call HME Technical Support at 1-800-848-4468.
Outside the USA, call your local HME representative for assistance.