User's Manual

13
3.1.3 Register Headsets to Base Station
Before you permanently mount the base station on the wall, you must register the
headsets to the base station, so they can be used in a walk test to determine where
the base station should be mounted for the best reception and transmission to/from
all the areas where they will be used.
After each headset has been “registered” to a base station, the base station will
recognize it when its power is on, and will be able to tell the difference between it
and other electronic equipment operating on similar frequencies.
Up to 15 headsets can be registered to a base station. If any is replaced, you must
register the new one before you use it. When a headset is replaced, the old one
remains in memory. If the maximum number of 15 (in memory) is exceeded, you
must clear some/all of the current registrations so that fewer than 15 headsets are
registered before you can register a new one.
Register each headset as follows:
Note: Headsets must be within 6 feet (1.83 meters) of the base station while being
registered.
 Be certain all headsets to be registered are turned off and the base station is
plugged in and its power is on. Others can be on or off.
 On the LANE STATUS display, press the Menu button.
 On the MAIN MENU display, press the Register headsets button.