User's Manual

12
Type A:
Type B:
3.1.1 Install Antennas on Base Station
Locate the two enclosed antennas, and install them
by screwing them onto the base station antenna
connectors, as shown in Figure 12.
3.1.2 Connect Base Station Power Supply
You may have Type A or Type B power supply, as illustrated in Figure 13.
Connect the power supply to the base station and an AC electrical outlet according
to the numbered instructions for your type power supply, as shown in Figure 13.
If necessary, refer also to the
wiring diagrams in Figures 28-38.
Note: If using a power source other than that supplied by HME, it must provide 24
volts DC regulated to +/-5%, be capable of supplying a minimum of 50 watts of power
and be “LPS” rated for safe operation of the unit. The power source must meet all
applicable local regulatory requirements.
Figure 12. Antenna mounting
Figure 13. Power supply connection to base station