Daim Ntawv Qhia Tus Neeg Siv

18
[YES] is used to arm, select, enter sub-menus and tick/untick boxes.
[NO] is used to negate, deselect or go back one or more steps.
4.2 PARAMETER EDITING
The DATA ENTRY knobs are used to change the values of the track parameters. The po-
sitions of the parameters on the screen correspond to the physical locations of the knobs
on the front panel. Some of the parameters on the screen tell you what DATA ENTRY knob
controls that particular parameter. For example “(E)”.
• The parameters are adjusted in larger increments if you press down the DATA ENTRY
knob while turning it. This makes it quicker to sweep through the whole parameter range.
• Press DATA ENTRY knob + [NO] to reset the parameter to the default value.
• Press [PARAMETER] key + [PLAY] to reset all the parameters in the selected parame-
ter page to default values.
• Press and hold a [PARAMETER] key to see the exact values of the parameters.
4.3 PARAMETER VALUE JUMP
Pressing [FUNC] while editing certain parameters will make the parameter values jump to
appropriate positions. The time of the Delay, for example, doubles and halves the value,
while the sample tuning will jump in whole octaves.
4.4 [FUNC] KEY PRESS COMBINATIONS
The standard way to use the [FUNC] key in combination with other keys, is to press and
hold [FUNC] and then make a short press on the second key in the combination. For
some key combinations, it is also possible to access a sub-menu by pressing and holding
[FUNC] + second key for a second.
4.5 QUICK SCROLLING
Scroll through menus using the LEVEL/DATA knob. Quick scrolling is possible on many
menus. Press [FUNC] + the [UP] or [DOWN] keys to move the cursor one menu page.