Phau Ntawv Qhia
Figure 1
W H D Weight
16-7/8" 22-3/4" 10-1/2" 46 lbs.
GR420
2.2.9 Insert the door disconnect plug into the disconnect recep-
tacle in the housing.
2.2.10 Securely install the proper lamp.
2.2.11 Close the door. Thread the captive door screws into the
housing. Tighten the captive door screws to 55 in. lbs. torque. This
is required for watertight door seal.
2.2.12 Aim the floodlight restricting mounting to
+ 90
o
from vertical
lamp base down.
2.2.13 Tighten the 1/2" diameter yoke bolts securely (approx. 50
ft.lb. recommended).
2.2.14 Energize the floodlight. Check its operation and for proper
area illumination. Adjust the aiming point as needed but within the
limits of the mounting restrictions.
2.3 Knuckle Fitter Mount Installation.
2.3.1 Slip the slip fitter of the knuckle fitter over the pole-top, tenon
or pipe bracket. Lightly tighten all four set screws evenly against
the pole-top, tenon or pipe bracket.
WARNING
DO NOT MOUNT THE KNUCKLE FITTER TO A
TENON OR BRACKET THAT IS MORE THAN 30
DEGREES FROM VERTICAL. MOUNTING AT AN
ANGLE GREATER THAN 30 DEGREES MAY RESULT
IN DISENGAGEMENT OF THE FITTER AND RESULT
IN SERIOUS INJURY OR DEATH.
2.3.2 Loosen the captive door screws attaching the door to the
housing. Open the door.
2.3.3 Detach the power disconnect plug from the disconnect
receptacle in the housing.
2.3.4 If needed, remove the door by removing the cotter pin from
the hinge pin and sliding the door hinge pins out of the housing.
2.3.5 Make all wiring connections in accordance with approved
wiring methods. Ensure that all supply wires and supply wire
connections are retained between the folds of the wire shield in the
housing.
2.3.6 If the door was removed as in 2.3.4 reinstalll the door by
sliding the door hinge pins into the housing. Insert the cotter pin
through the hinge pin.
2.3.7 Insert the door disconnect plug into the disconnect recep-
tacle in the housing.
2.3.8 Securely install the proper lamp.
2.3.9 Close the door. Thread the captive door screws into the
housing. Tighten the captive door screws to 55 in. lbs. torque. This
is required for watertight door seal.
Figure 2
GR509B
DISCONTINUED