Installation Instructions

currentlighting.com

without notice. All values are design or typical values when measured under laboratory conditions.

Page 3 of 4

Rev 08/01/22

NXSMP2-SMI_install_sheet_R01

93147263 Rev. A

INSTALLATION FOR INFIXTURE DEPLOYMENT

5. Once all connections are made take one of the provided MAC Address labels and affix it to the outside of the luminaire in a visible

location. This will be used by the Field Engineer to program and calibrate the sensor during system startup. NOTE: Provide the

additional labels in packaging for use in field on layouts, drawings or similar project documentation.

6. After install is complete perform end of line testing as provided by HCS for verification of performance.

FOR SENSOR PROGRAMMING SEE QUICK STARTUP GUIDE FOR DISCOVERING AND CONFIGURING NXSMP SERIES SENSORS.

2.000

(Cutout)

Slot Detail - Sheetmetal

.682 (Cutout)

Slot Detail - Plastic

.682 ± .008

.022

R .062

92º

2.015 ± .020

MOUNTING DETAIL

WIRING DIAGRAM

NXSMP2-SMI with NXFM2-1R2D-I-UNV

Pink (-)

NXFM2-1R2D-I-UNV

Pink wire replace previous gray wire. Unit with a gray instead of pink wire should be wired as the pink wire shown in the diagram.

NXSMP2-SMI