Installation Instructions
93147266 Rev. A
currentlighting.com
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 3 of 4
Rev
08/01/22
NXSMP2-
OMNI_install_sheet_R01
INSTALLATION FOR CEILING MOUNT DEPLOYMENT (CONTINUED)
5.
Once all connections are made take one of the provided MAC Address labels and affix it to the reflected ceiling plan, layouts,
drawings or project documentation identifying its location. This will be used by the Field Engineer to program and calibrate the
sensor during system startup.
INSTALLATION FOR IN-FIXTURE DEPLOYMENT
6.
Choose a mounting location on the housing or lens with a flat surface where the sensor face and sensor lens will be oriented in the
downward position as close to level as possible. NOTE: The sensor should be clear from obstructions to ensure proper detection.
7.
Once a position is selected a 1-2/5” to 1-
1
/
2
”
round opening in the housing or lens needs to made in order for the sensor to slide
into position. After the sensor is in position use the provided locking ring and gasket to secure the sensor in place. NOTE: Do not over
tighten the locking ring and gasket. This can cause damage to either the fixture or gasket.
8.
After the sensor is mounted locate the miniature 4-pin SmartPORT positioned on the back of the sensor. Using a NXCBL-I or
NXCBL-O insert the connector into the back of the sensor.
9.
Once the cable has been connected to the sensor connect the opposite end of the NXCBL to additional NX Devices mounted
inside the luminaire.
10.
Once all connections are made take one of the provided MAC Address labels and affix it to the outside of the luminaire in a visible
location. This will be used by the Field Engineer to program and calibrate the sensor during system startup. NOTE: Provide the
additional labels in packaging for use in field on layouts, drawings or similar project documentation.
11.
After install is complete perform end of line testing as provided by HCS for verification of performance.
FOR
SENSOR
PROGRAMMING
SEE
QUICK
STARTUP
GUIDE
FOR
DISCOVERING
AND
CONFIGURING
NXSMP2
SERIES
SENSORS.
MOUNTING
DETAIL
NXSMP2-
OMNI
(Profile View)
NXSMP2-OMNI
(Profile View)
NXSMP2-
OMNI
(Profile View)
WIRING
DIAGRAM
Fixture Mount
HOLE DETAIL
Ø
1.44”
NXSMP2-OMNI
(Profile View)
NXSMP2-
OMNI
Ceiling Mount
NXSMP2-OMNI with NXFM2-1R2D-I-UNV
Pink wire replace previous gray wire. Unit with a gray instead of pink wire should be wired as the pink wire shown in the diagram.
NXSMP2-OMNI
Pink (-)