Safety Instructions
currentlighting.com
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change without notice.
All values are design or typical values when measured under laboratory conditions.
Page 3 of 3
(Rev 09/13/22)
NXSMDT-OMNI-Install-Sheet
93165408 Rev. B
2. Aach the sensor to the mounting plate by aligning the keys in the mounting plate with those in the sensor housing. Rotate the
sensor housing until proper orientation is achieved.
3. Plug the CAT5 cable into any available SmartPORT™ on the NX™ Room Controller. Verify solid snap-in connection.
4. Route the CAT5 cable from the Room Controller to the Occupancy Sensor. NOTE: Low voltage wiring must be isolated from line
voltage wiring. Consult National and Local Electrical Codes for conduit requirements
5. Plug the CAT5 cable into the NXCBL-P connected to the Sensor. Verify solid snap-in connection. NOTE: If using multiple
NXSMDT-OMNI sensors in a daisy chain configuration NXCBL-P2 must be used to provide in and out connection.
6. Once all connections are made take one of the provided MAC Address labels and ax it to the reflected ceiling plan, layouts,
drawings or project documentation identifying its location. This will be used by the Field Engineer to program and calibrate
the sensor during system startup.
FOR SENSOR PROGRAMMING SEE QUICK STARTUP GUIDE FOR DISCOVERING AND CONFIGURING NXSMDT-OMNI SENSORS.
INSTALLATION FOR CEILING MOUNT DEPLOYMENT
WIRING DIAGRAM
MOUNTING DETAIL
Mounting Method 1: Screw and mount
twist-lock cover plate.
Mounting Method 2: Twist and lock
threading mounting post into cover plate.
Drill into ceiling tile.
Run wiring through ceiling
tile. Aach sensor body
to cover plate by aligning
arrows and twist locking
into place. Connect wiring
with wire nuts.