User's Manual

WL-3002 User’s Manual
HL-TECH Corporation
9
1.1.2 Encryption Setting
1.1.2.1 WEP Key Setting
Press “WEP Encryption Setting” in Figure 1-2 to enter the “WEP Key Setting” page
Figure 1-3
 Select the “Open System” , “Shared Key” mode or “Auto” from the “authentication
Mode” drop down menu.
 Press the “Change” button to modify the contents of “WEP Key setting”, when it is
finished, press “Apply” to save it. The button “Change” and “Apply” is alternately
shown on the same position.
 Select which key length 64,128 or 256 bits will be modified or used by “Key
Length” item.
 Select which key set will be use by the field of “Default Key ID”
 Modify the 4 sets key depending on the selected key length on the field of “Key
Value”. The key value is used the hexadecimal format.
 Select which key format “hexadecimal” or “ASCII” will be used from the “Key
Format”