Instructions / Assembly

Installation Manual For Wall Lamp

(Warning: Cut Off The Power Before

Installation To Prevent Electric Shock)

1. Before installing lamp, First, remove the lamp mounting plate (hand unscrew the two mounting

plate mounting flower nuts on the lamp surface), and then fix the mounting plate on the mounting

position screw hole with the screw.

2. Using the wiring cap in the accessory kits, then Connecting the L wire marked on the lamp with

the live wire of the appliance, the N wire marked with the neutral wire of the appliance, and the

bare copper wire with the ground wire of the appliance.

3. Install the mounting hole of the lamp on the mounting screw rod of the mounting plate, and then

tighten and fix the lamp with the flower nut

4. Remove the lamp head ring, and then install the lampshade mounting hole into the lamp head and

tighten the ring

5. Install the suitable bulb into the lamp head and screw it properly, Lighting and complete the

installation

Accessories List:

Screw

Wire connector

Instruction

2PCS 3PCS 1 PCS

It is Equipped With a Dawn to Dusk

Sensor, Which Automatically Turns on at

Night and Turns Off at Dawn.Needs to be

Directed Towards the Direction of Open

Space With Sunlight, and Cannot be

Installed in the Place Where the Object

is Always in Darkness or Cove.( Note:

The lamp can not be installed in the

direction of the lamp probe light

reflection environment, otherwise it

will affect the normal use of the lamp.)

Mounting plate

flower nuts

Lampshade

Ring