User Guide

Copyright HK Instruments 2021 www.hkinstruments. User guide version 1.0 2021
Page 4
Step 2: Brightness control
2) Choose Brightness.
1) Press to enter the sengs menu.
OK
OK
+
–
Settings
Display values
Brightness
Modbus
3) Adjust the brightness.
• Increase/decrease the brightness by pressing
and .
+
–
OK
+
–
Brightness
4) Saving the chosen brightness level and exing.
• Save the brighness level and return to the sengs
menu by pressing the buon or keep the
buon down to return to the basic view.
• The chosen brightness level will sele when the
buons have been unpressed for 30 seconds.
OK
OK
Step 3: Modbus settings (Modbus devices only)
2) Choose Modbus.
1) Press to enter the sengs menu.
OK
OK
+
–
Settings
Display values
Brightness
Modbus
OK
+
–
Modbus
Address 1
Baudrate 9600
Parity none
OK
+
–
Address
1
Address: 1 – 247 (default = 1)
Baud rate: 9600 / 19200 / 38400 / 57600
Parity: none / even / odd
OK
+
–
Baudrate
9600
OK
+
–
Parity
none
4) Choose Exit to exit the Modbus menu.
• Scroll to Exit and press to return to the
sengs menu or keep the buon down to
return to the basic view.
OK
OK
OK
+
–
Modbus
Exit
Baudrate 9600
Parity none
3) Choose the desired parameters in the Modbus menu.
• The parameters can be scrolled by pressing the
and buons and chosen by pressing .
+
–
OK
Figure 2a
Figure 2b
Figure 3a
Figure 3b
Figure 3c
This adjusts the brightness of the display in stand-by mode.
The brightness of the display is always at the maximun level
when the buons are used.