User Manual

C-SERIES ACCESSORIES / MOUNTINGHIVE LIGHTING21 22
STANDARD YOKE
STUDIO YOKE
All C-Series lights may be operated when
securely mounted to a separate apparatus,
such as a stand (purchased separately).
Carefully position the light above stand. Place
the top of the stand into the 5/8th (16mm)
receiver mount, located on the base of the
yoke. Continue to hold the light securely with
one hand, and use the other to twist the Yoke’s
locking knob clockwise until tight.
Tilting (Vertical Adjustment)
Loosen the tilt lock on the yoke until the light
can move freely. Adjust the light upward or
downward at any angle between 0° and 180°
(vertical). Secure the tilt lock once desired
angle is reached.
Panning (Horizontal Adjustment)
Loosen the mount lock on the yoke. Freely
adjust the light left to right up to a full 360°
horizontal rotation. Secure the mount lock
once desired angle is reached.
All C-Series lights may be operated with
Hive’s studio yoke when securely mounted
to a permanent or temporary lighting grid or
truss (sold separately). Carefully position the
light below the pipe or truss. Place the opening
of the pipe clamp located on the base of the
yoke so that the top of the hook rests securely
on the pipe or rod. Continue to hold the light
securely with one hand, and use a wrench, vice
grip or similar tool (sold separately) to twist
the mount’s locking screw clockwise until tight.
Tilting (Vertical Adjustment)
Loosen the tilt lock on the yoke until light
can move freely. Adjust the light upward or
downward at any angle between 0° and 180°
(vertical). Secure the tilt lock once the desired
angle is reached.
Panning (Horizontal Adjustment)
Loosen the mount lock screw on the pipe
clamp. Freely adjust the light left to right up
to a full 360° horizontal rotation. Secure the
mount lock once the desired angle is reached.
MOUNTING