User Manual

page 21
board are used to operate
the light. The starting
address can be any value
between 1 and 512.
Selecting the one you
want can be achieved in
two different ways via the
control panel’s Right Dial:
a. Fine Adjustment:
Press the right dial in
slightly, then continue
to press in the dial while turning in either
direction to change the active property’s value
by increments of 1.
b. Coarse Adjustment: Turn the right dial in either
direction. The starting address’ value will now
change in increments of 10.
NOTE: Any values for S, H, D & C that have been provided by
the DMX board will persist even after the DMX board has been
unplugged. Conversely, if the controls on the DMX board are
adjusted post-separation and then the board is reconnected, the
light will read the updated values, overwriting the previous ones.
DMX CHANNELS
Channel Property DMX 0 DMX 255
Channel 1 Dimming Off Full brightness
Channel 2 CCT control 1,650K 8,000K
Channel 3 Saturation
0% Saturated
(White Light)
100% Saturated
(Full Color)
Channel 4 Hue 0 Degrees hue 360 Degrees Hue